Shoutout to the guy at the Lodi job who caught my outrigger pad sinking
I was setting up a 60 ton on soft dirt near a drainage ditch in Lodi on a Tuesday morning, and I had my pads down but hadn't checked them after the boom came up. A laborer walked over and said my rear pad had sunk about 4 inches into the mud, which I never felt from the cab. I shut it down right there, pulled the boom in, and we cribbed it with three layers of 4x4 oak and some plywood on top. Cost me 45 minutes and maybe $60 in lumber, but a tip-over would have been a whole different story. Now I walk my pads after every boom extension, not just at setup. Anyone else have a close call where somebody on the ground spotted something you couldn't see from the seat?
4 inches is a lot to sink without feeling it from the seat, that's what gets me. You trust the bubble and the pads look fine at setup, then the ground just gives up under the load once that boom swings out. Good thing that laborer was paying attention, most guys would've walked right past it.